[Rodney Thayer]

rebuild the kernel and make sure it's got your ethernet device configured 
(or whatever net device you use)

then, make sure that during boot-up it finds your net device.  the code seems to
go out and sense the devices so if it's physically not there, or at the wrong
address, you don't see it. this can be observed by carefully watching the
messages that happen at startup.  they MIGHT go in the system log too (do 
man syslog to find the system log)

good luck!

>I did the netconfig for setting up my IP, route and nameserver
>software stuff in LINUX.  However, upon bootup I get 
>the following messages:
>
>SIOCSIFADDR: No such device
>SIOCSIFBRDADDR: No such device
>SIOCSIFNETMASK: No such device
>SIOCADDTR: Network is unreachable
>SIOCADDTR: Network is unreachable
>
>I have noticed that in my /dev directory I do not
>have any eth? devices.  Any advice?
>
>Jim
>jim at sherwood.mv.com
>jas at enteprise.uml.edu
>
>
>
>
>

                       Rodney Thayer           ::    rodney at sabletech.com
                       Sable Technology Corp   ::         +1 617 332 7292
                       246 Walnut St           ::    Fax: +1 617 332 7970
                       Newton MA 02160 USA     ::    PGP:    request sig.
                              "Developers of communications software"